Line 6 StageSource L2t Acoustic Guitar Amp / Loudspeaker

Acoustical
System Type: 0", 2-way, bi-amplified loudspeaker system
Frequency Range (-10dB): 44Hz to 19kHz, (Reference/P.A. Speaker Mode, free-field)
Frequency Response (±3dB): 51Hz to 18kHz, (Reference/P.A. Speaker Mode, free-field)
Maximum SPL Output: 128dB peak @ 1 meter (unweighted, measured indoors with music program material)
Coverage Pattern (-6dB): 100 horizontal x 50 vertical
Directivity Factor (Q): 9.2 (averaged 1kHz to 16kHz)
Directivity Index (DI): 9.6dB (averaged 1kHz to 16kHz)
Crossover Frequencies: LF to HF Crossover - variable, 2.2kHz to 7.0kHz (Speaker Mode dependent)
Low-Frequency Transducer: 10" extended range woofer, 2" diameter voice coil, 4 ohm impedance
High-Frequency Transducer: 1" exit compression driver, 1.4" diameter voice coil and diaphragm, 8Î impedance
Electrical: Rear Panel
Input Types: Line-level XLR-1/4", balanced Stereo RCA, unbalanced L6 LINK XLR
Input Impedance: 100 kohm balanced 20 kohm balanced N/A
Max Input Levels: +20dBu +16dBV N/A
Onset of Limiting: +6dBu input (Reference/P.A. Speaker Mode, Master Level control at center-detent)
-6dBu input (Reference/P.A. Speaker Mode, Master Level control at maximum)
Output Types: Balanced Loop Thru XLR Balanced Mix Out XLR L6 LINK XLR
Output Impedances: Source-dependent 680 ohm balanced N/A
Controls: Feedback Suppression On/Off/Mode, Master Level, Speaker Mode
Indicators: Signal Present/Clip, Feedback Suppression On/Off/Mode, Limit, 6x Speaker Mode, L6 LINK Status
Electrical - Side Panel
Input Type: 2x mic/instrument XLR-1/4", balanced
Input Impedance (each input): 2.63 kohm balanced (Pad = 0dB), 23.7 kohm balanced (Pad = 20dB)
Gain Range (each input): -infinity to +57dB (Pad = 0dB); -infinity to +37dB (Pad = 20dB)
Max Input Level: +25dBu (Gain at minimum ˜on' position, 20dB pad on)
Controls:
2x Gain, 20dB Pad, LF Level, MF Freq & Level, HF Level, Mod Level, Reverb Level, Feedback Suppression On/Off/Mode, 1x Dual Mono/Stereo Link Mode, Acoustic Modeling Amount, On/Off
Indicators: 2x Signal Present/Clip, 2x Feedback Suppression On/Off/Mode, 1x Acoustic Modeling On/Off
Digital Signal Processing
Speaker Modes: Reference/P.A., Playback, Floor Monitor, Keyboards, Acoustic Guitar, Electric Guitar
On-board Effects: Reverb, Modulation, Feedback Suppression, Acoustic Modeling
Transducer Protection: Excursion limiting, thermal limiting
Digital Networking: L6 LINK intelligent speaker networking system
Sensors: Speaker orientation, pole sensor, power amp temperature, power supply, temperature
Power Amplification and Supply
Output Channel: HF LF
Power Amplifier Type: Class AB Class D
Peak Output Power1: 175 watts 655 watts
Power Supply Voltage Range: 100 - 240 VAC, ± 10%, 50/60Hz , automatic voltage selection
Power Consumption: 250 watts (1/8th power)
Cooling: Digitally controlled, variable-speed 50 mm fan
Protection: Output overcurrent, overtemperature, DC fault
One 1kHz sine wave input, 1% THD+N unweighted into the nominal load impedance, single-channel driven, before the onset of limiting.
Mechanical
Enclosure: 15 mm enclosure, 18 mm baffle, multi-ply hardwood, textured black paint, bass, reflex design
Floor Monitor Upward Angle: 60 using kickstands, 30 using handle
Suspension Points: M10 x 1.5 threaded inserts, qty: 4
Pullback Point: M10 x 1.5 threaded insert, qty: 1
Grille: 18-gauge perforated steel, black powder coat finish
Pole Cup: 35 mm pole cup with sensor
Dimensions (HxWxD): 23.75" x 12.25" x 12.25"
Weight: 39.1lb